MIL-M-60144A(Mu)
TABLE III (Cont'd)
CHARACTERISTIC
REQUIREMENT
TEST PROCEDURE
403. Temperature (storage)
3.5.1
4.6.2.1
4 0 4 . Temperature (operating)
3.5.2
4.6.2.2
4.4.1 Failure of sample.- Should any one, item of a special sampling
fail to meet the specified test requirements, acceptance of the product
shall be suspended by the Government until necessary corrections have
been made by the contractor and resubmitted samples have been approved
(see 4.3.3).
4.5 Inspection equipment.-
Except as otherwise provided for by the
contract, the contractor shall supply and maintain inspection equipment
in accordance with the applicable requirements of MIL-I-45607.
4.5.1 Gove rnment furnished inspection equiPment,- Where the contract
provides for Government furnished test equipment, supply and maintenance
of test equipment shall be in accordance with the applicable requirements
specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design.- Unless otherwise specified in the con-
tract, all inspection equipment specified by drawing number in specifica-
tions or SQA2 forming a part of the contract shall be supplied by the con-
tractor in accordance with technical data listed in the List of Inspection
Documents when provided with the technical data package (TDP).
4 . 5 . 2 . 2 con t r a c t o r d e s i g n T h e contractor shall design and supply
i n s p e c t i o n equipment compatible with the "Test Methods and Procedures"
s p e c i f i e d in 4.6 of this specification and with the component inspection
p r o c e d u r e s specified in "Examination" and " T e s t f a c i l i t i e s " r e q u i r e m e n t s
of MIL-F-13926. Since tolerance of test equipment is normally considered
to be within 10% of the product tolerance for which it is intended, this
inherent error in the test equipment design must be considered as part of
the prescribed product tolerance limit. Thus, concept, construction, ma-
terials, dimensions and tolerances used in the design of test equipment
shall be so selected and controlled as to insure that the test equipment
will reliably indicate acceptability of a product which does not exceed
90% of the prescribed tolerance limit, and permit positive rejection when
non-conforming.
Construction shall be such as to facilitate routine cali-
bration of test equipment.
4.6 Test methods and procedures.
4.6.1 Treatment, moisture and fungus-resistant. - The control motor
s h a l l be tested in accordance with MIL-T-152 to insure compliance with
3.3.1.
4 . 6 . 1 . 1 I n d u c t a n c e t e s t . : W i t h the control motor stabilized at 80°
+ 10°F, connect an impedance bridge across the brush terminals and measure
t h e inductance for compliance with 3.3.2.
6.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business